Used to make secure, code-approved connections on PEX tubing supply lines. PEX is flexible, resists scale, and is faster to run than copper in most shower rough-ins.
Shower installation New Braunfels TX built to last
When you need shower installation New Braunfels TX homeowners trust, Comal Crest Plumbing handles the whole job: tear-out, valve rough-in, shower pan, tile-ready waterproofing, and final trim. We have served Comal County since 2010, and we install Moen, Delta, and Kohler fixtures daily.
Serving new braunfels and nearby areas.
How big is the shower job?
Pan and valve
New pre-sloped pan, new valve, new waterproofing behind the wall.
- 1. Valve swap Replace the valve and trim, keep the existing pan and surround.
- 2. Pan and valve New pre-sloped pan, new valve, new waterproofing behind the wall.
- 3. Full rebuild Tear-out, drain relocation, new pan, new valve, new surround or tile.
Drag the needle to compareTouch and drag the needle
- 30Services from one local team
- 20Areas served around new braunfels
- Flood testPan holds water overnight before tile
- Pressure testSupply lines checked before the wall closes
What our shower installation includes
Every shower installation we do covers the plumbing rough-in, the pan, the waterproofing, and the final fixture trim. Tile and glass are separate unless you ask us to coordinate them.
Work order
Shower Installation- Valve and supply rough-in: We remove the old valve and install a new pressure-balancing or thermostatic valve at the correct depth for your finish wall. We run new PEX tubing or copper pipe to the showerhead and any body sprays, and we pressure-test the lines before the wall closes.
- Shower pan and drain: We set a new shower pan with a pre-slope toward the drain, then install the waterproof membrane or foam board system. The drain gets set at the right height for the pan and tested for flow. This is the step that prevents leaks into the floor below.
- Waterproofing and flood test: Every seam, corner, and penetration gets sealed. We flood-test the pan overnight before tile goes on. If it holds, we move forward. If it does not, we find the leak and fix it while the wall is still open.
- Fixture and trim installation: We install the showerhead, handle, and any additional trim. We run hot and cold through the valve to confirm the cartridge is oriented correctly and the temperature holds. We check the drain for proper flow and confirm no weeping at any connection.
- Debris removal and cleanup: We haul off the old shower, pan, and valve, and we leave the bathroom broom-clean. You get a walkthrough at the end where we show you how to operate the valve and clean the finish so it stays looking new.
What the first visit covers
First visit
We measure the space, check the drain and valve, test water pressure, and write up a scope with fixture options.
Shower work at your home
We install and replace showers in houses across New Braunfels and Comal County.
Cracked pan
New pre-sloped pan with waterproof membrane
Failed valve
Replace valve body, cartridge, and trim
Tub to walk-in
Relocate drain, frame for curbless entry
Low pressure
Test supply lines, install balancing valve
Shower work at your business
We handle shower installation and repair for commercial properties in the New Braunfels area.
Rental units
Fast valve and pan replacement between tenants
Gyms and locker rooms
Multiple shower heads and drain lines
Small hotels
Guest bathroom shower replacement and repair
Shower installation New Braunfels TX done right
A shower is plumbing, not just tile. The pan, the drain, and the valve decide whether it stays dry. Do those right and the finish lasts.
That means cutting out the old drain, setting a new shower pan with the correct slope, roughing in a pressure-balancing or thermostatic valve, running PEX tubing or copper pipe to the new fixture locations, and sealing every penetration before tile goes up. We follow the Uniform Plumbing Code and International Plumbing Code on every job, and we pressure-test the supply lines before the wall closes.
Most of our shower work starts with a failure or a frustration. A 1990s fiberglass pan cracks and leaks into the ceiling below. A guest bathroom in River Chase still has a 30-inch stall nobody fits in. A homeowner in Vintage Oaks wants a curbless walk-in shower installation New Braunfels Texas style, with a linear drain and a bench. We also get calls for same day shower installation New Braunfels TX when a valve fails and the water cannot be shut off. Whatever the reason, we scope it, price it, and get it done.
- When it helps
- Leaks, low pressure, cracked pans, or a remodel
- What you get
- New pan, valve, waterproofing, and fixture trim
How our shower installation process works
Five steps, no surprises. Here is exactly what happens from the first phone call to the final walkthrough.
Tools and methods we use on shower jobs
Each method answers a different question. Together they leave very little to guess.
Used for copper pipe connections where copper is the right choice, such as certain valve bodies and older homes. We sweat the joints clean and pressure-test before closing the wall.
Cuts copper, PEX, and CPVC cleanly so connections seat properly. A square cut is the difference between a joint that holds for decades and one that weeps.
Used to find hidden leaks behind shower walls and under pans before we open anything up. It saves you from exploratory demolition and gets us to the source faster.
Used when a shower backs up and we suspect the problem is in the drain line, not the shower itself. The camera shows us root intrusion, bellies, or collapsed pipe.
When to schedule a shower installation
A homeowner in River Chase has a 1990s fiberglass shower with a cracked pan and a stained ceiling below.
We tear out the old surround and pan, check the subfloor for rot, and install a new pre-sloped pan with a waterproof…
HomesA couple in Vintage Oaks wants to convert a 60-inch tub to a curbless walk-in shower for aging-in-place.
We relocate the drain, frame and block for grab bars, install a linear drain and a low-curb or curbless pan, and set…
HomesA property manager in Creekside has a rental unit where the shower valve failed and water is running.
We respond the same day, shut down the supply, and replace the valve body and trim.
BusinessesA homeowner in Gruene is remodeling a guest bathroom and wants a new shower plus a new sink faucet and toilet.
We handle the shower installation and, in the same visit, install the new faucet and toilet.
Homes
How shower installation works in New Braunfels
New Braunfels sits on Comal County limestone, and that geology shapes how we handle shower drains and supply lines. Limestone is hard, so drain relocations take longer and often require a concrete saw and a jackhammer.
Downtown New Braunfels
Older homes with galvanized or early copper supply lines. We often find corrosion behind shower walls and replace the section while the wall is open.
Gruene
A mix of historic homes and newer builds. Historic homes may need drain relocation and careful framing to preserve the structure.
Veramendi
Newer construction with PEX supply lines. Builder-grade shower pans are a common failure point, and we replace them with pre-sloped pans and proper waterproofing.
- Downtown New Braunfels
- Gruene
- Veramendi
- Vintage Oaks
- River Chase
From problem to finished result.
Slide to compare the photo with an illustrative inspection view. It is generated from the photo, not a measurement.
PhotoCracked fiberglass pan to walk-in shower
Before: A 1990s fiberglass shower in River Chase had a cracked pan leaking into the ceiling below. The valve was original, the surround was stained, and the homeowner was using a bucket to catch drips.
After: We tore out the old shower, replaced the valve, and installed a pre-sloped pan with a waterproof membrane and a new walk-in surround. The ceiling stain was repaired, and the shower passed a 24-hour flood test with no leaks.
Tub to curbless walk-in conversion
Before: A couple in Vintage Oaks had a 60-inch tub they could no longer step over safely. The drain was at the tub end, and the bathroom had no blocking for grab bars.
After: We relocated the drain, framed and blocked for grab bars, and installed a curbless pan with a linear drain and a thermostatic valve. The shower holds temperature within 3 degrees Fahrenheit when the sink runs.
Builder-grade stall to full shower replacement
Before: A homeowner in Veramendi had a 30-inch builder-grade stall with a failing valve and low pressure. The cartridge was scaled from hard water and the showerhead put out a weak spray.
After: We replaced the valve with a pressure-balancing model, ran new PEX supply lines, and installed a WaterSense showerhead. Pressure improved and the temperature no longer swings when the toilet flushes.
Shower problems we fix for New Braunfels homeowners
Most shower calls start with one of these.
Cracked shower pan leaking into the ceiling below
Water soaks the subfloor and framing, which leads to rot, mold, and eventually a structural repair that costs far more than a new pan.
Shower valve fails and water will not shut off
Water runs continuously, your bill spikes, and the risk of damage to the wall and floor grows by the hour. Call us for emergency plumbing.
Low water pressure or temperature swings in the shower
A shower that scalds then freezes is more than annoying. It is a safety risk, especially in homes with kids or older adults.
Outdated 30-inch stall nobody fits in
A cramped shower is hard to use and hurts resale. Buyers notice a dated stall immediately, and it becomes a negotiation point at inspection.
Why homeowners upgrade their shower
A new shower is not cosmetic. It stops leaks, fixes pressure problems, and adds usable space. Here is what a properly installed shower gets you.
Stop hidden water damage
A failed shower pan or cracked tile grout can push 5 to 20 gallons a week into your subfloor and framing.
Fix pressure and temperature swings
Old two-handle valves and clogged cartridges cause the classic scald-then-freeze.
Gain real usable space
Swapping a 60-inch tub for a walk-in shower adds roughly 8 to 12 square feet of usable floor.
Raise resale value
A clean, code-correct shower is one of the first things a New Braunfels buyer inspects.
What you receive on the job
Clear records you can keep and share.
Written scope
Fixture options and a firm price before work starts
Flood test record
Pan holds water overnight before tile goes on
Photo documentation
Rough-in and waterproofing photos for your records
16 years installing showers in Comal County
Comal Crest Plumbing has been installing and replacing showers in New Braunfels since 2010.
Valve depth
We measure from the stud face to set the valve at the right depth for the finish wall.
Pan slope
We check the slope toward the drain so water moves fast and does not pool.
Supply pressure
We read the gauge on the supply lines before closing the wall to catch any weeping joint.
Is your New Braunfels area covered?
Type your ZIP code or town. If you are outside the list, call and ask.
new braunfels ZIP codes
- 78132
- 78130
- 78131
- 78135
Towns we serve.
Based in new braunfels and covering the places around it. Pick one for local details.
What New Braunfels homeowners say
Our builder-grade shower pan cracked and we had water staining the ceiling below. Comal Crest came out, confirmed the pan was the source, and replaced the whole shower with a walk-in. They pressure-tested before tile and showed me the flood test. Four days start to finish. No leaks, no callbacks, and the price matched the written quote.
We converted a 60-inch tub to a curbless walk-in for my father. The crew handled the framing, the linear drain, and the blocking for grab bars. They explained the slope and why it mattered. My father can step in without a curb now, and the shower drains fast. Worth every dollar.
I manage several rentals and had a shower valve fail on a Saturday. Comal Crest got a tech out the same day, shut the water down, and came back Monday to replace the valve and trim. They handled the tenant communication and left the unit clean. I have used them for three more units since.
Frequently asked questions about shower installation
Short answers for the first few minutes. The team can cover the rest.
Still have a question?
Describe what you are seeing and we will point you to the right next step.
(737) 707-1110A simple valve and pan replacement sits at the low end. A full tear-out with new tile, linear drain, and custom pan runs higher. We give you a written price after we see the space, not a phone estimate.
Shower installation involves supply lines, a drain connection, and a valve that has to be set at the right depth and tested.
A standard shower replacement takes two to four days of plumbing and pan work, plus tile time if you are tiling. Demo and rough-in are typically one day. Pan and waterproofing are another day, with a flood test overnight. Trim and final test take a few hours. If you are converting a tub to a walk-in, add a day for framing and drain relocation.
Yes. We install walk-in and curbless showers across New Braunfels and Comal County, including Gruene, River Chase, Vintage Oaks, and Veramendi. We handle the framing, blocking for grab bars, linear or center drain, and the waterproofing. If you are planning for aging-in-place, tell us up front and we will set the blocking and slope for a low or zero curb.
Other plumbing services we handle
Other services from the same team.
Get your shower installation New Braunfels TX quote
(737) 707-1110Call Comal Crest Plumbing and we will come out, measure the space, and give you a written price for your shower installation or replacement.
Call Comal Crest Plumbing
Reach us at (737) 707-1110 any time, day or night. For standard repairs we book same-day slots and call ahead with a real arrival window. For emergencies, we dispatch immediately. You can also email info@comalcrestplumbing.com and we will get back to you the same business day.